Table of Contents
Advertisement
Notes
Notes on FTP Server System Design
1. In a case where an FTP client writes a recipe file to the CF card inserted in the V8, the recipe file
from the FTP client and the recipe in operation in the V8 must be in the same format.
In a case where a recipe file is written to a remote location, be sure in advance that writing is
enabled in the target location.
2. Before using an FTP client tool, read its manual to understand the functions and operational
procedures, and also conduct a trial operation.
The V8 (FTP server) may not support some functions, depending on the model of the FTP client
tool.
Notes on File Transfer
1. If no command is sent from the FTP client within the time specified for [Input Supervisory Period] in
the [FTP Server Setting] dialog, connection between the FTP server and the FTP client will be
disconnected automatically.
2. While the V8 is in communication with the FTP client, setting the V8 to local mode (Main Menu
screen) disconnects them.
3. While the V8 is accessing a file in the CF card, do not allow the FTP client to write to or delete the
same file.
Such an action will cause a malfunction. A file deletion from the CF card, even while the V8 is not
accessing the file, will cause a file reading error at the time of the next access by the V8.
Basically, for any files relevant to V8 operation, do not execute the writing and deleting commands.
4. When a file in the CF card has been overwritten via the FTP server, check that the data in the file
is correct.
If writing to the file ends in error, the file will be deleted from the CF card. In the event of such a
deletion, repeat writing from the FTP client.
5. If the FTP client is down, wait until the time for [Input Supervisory Period] elapses and then retry
logging in.
6. While the FTP client is accessing a file in the CF card inserted into the V8, do not shut off the V8.
Doing so may corrupt data on the CF card.
7. If the V8 is reset or shut off while its connection with the FTP client is established, the next action
that the FTP client takes depends on the specifications of the FTP client tool.
With this in mind, choose an FTP client tool which supports the detection of a FTP server down
and also the safe termination in such a case.
8. If the CF card cover is open on the V8, access to the CF card is not allowed.
9. Depending on the model of the FTP client tool, there may be a mismatch in timestamp between a
file in the CF card and the FTP client tool. If such a mismatch is found, check the configuration of
the FTP client tool.
16
FTP Server
16
16-21
Advertisement
Table of Contents
