FE MONITOUCH V8 SERIES Reference: Additional Functions page 490

Setting Procedure
There is no special setting required for using a USB FDD.
Applicable Media
• 2HD type (1.44 MB, PC/AT format)
• 2DD type (640 kB, MS-DOS format)
Available Functions
Macro Command
• COPY_FILE
System Memory
The system memory addresses relating to the USB FDD are shown below.
Address ($s)
1025 USB FDD (drive: A)
1026 USB FDD (drive: A)
1027 USB FDD (drive: A)
1028 USB FDD (drive: A)
• Address $s1025
The result of access to the USB FDD port (drive: A) is output.
4
6
7
12
15
16
• Address $s1026 - 1027
Stores the free capacity on the USB-FDD port (drive: A) in kB.
• Address $s1028
Stores the status of the [Function: CF Card Removal] switch.
[0]: Switch OFF
[Other than 0]: Switch ON
Description
FDD error state
FDD free capacity (low-order) Unit: kB
FDD free capacity (high-order)
[CF Card Removal] switch status
Floppy disk not mounted
Too small floppy disk size
Different floppy disk type
Floppy disk write error
Disk error (open failure)
Floppy disk read error
(CF card removal disabled)
(CF card removal enabled)
26.6 USB FDD (Floppy Disk Drive)
Memory Type
← V
26
26-13