FE MONITOUCH V8 SERIES Reference: Additional Functions page 501

27 Ladder Transfer via USB or Ethernet
COM Port Setting for PLC
Once you have specified a COM port in the [Ladder Transfer Setting] dialog in LadderComOp, set the
COM port in the dialog shown below in the programming software for your PLC.
In the case of ladder transfer via USB, turn on the V8 unit and establish its connection with the
computer via a USB cable before proceeding to the COM port setting. Otherwise, the specified COM
port cannot be identified.
MITSUBISHI ELECTRIC "GX Developer/Gx Works2"
OMRON "CX-Programmer"
[Network Settings] dialog → [Driver] → [Port Name]
For [Baud Rate], specify the same value between the V8 unit and the PLC.
Panasonic "FPWIN GR"
[Communication Settings] dialog → [Port No.]
For [Baud Rate], specify the same value between the V8 unit and the PLC.
Yokogawa Electric "Wide Field2"
[Environmental Settings] dialog → [Communication Settings] → [COM Port No.]
27-10
If your computer has no serial port, selecting a COM port may be disabled, depending
on the PLC programming software. Proceed to LadderComOp setting beforehand. For
the setting procedure, refer to the sections shown below for the ladder transfer function.
• "Ladder Transfer via USB" page 27-6
• "Ladder Transfer via Ethernet" page 27-8
Specify the same value as
the baud rate between the
V8 unit and the PLC.