Table of Contents
Advertisement
Step 3
Select [Parts] and click [OK].
The [Image Conversion] dialog is displayed.
Step 4
Choose the part type.
Choose [Lamp] here.
Step 5
In the case of a switch or lamp part, specify the number for [No. of Patterns].
Select "2" here.
The pasted image is regarded as the OFF image.
(The ON image must be set later.)
Step 6
Click the [ON] button.
Click the [Change] button. The [Image List] dialog for bitmap image selection is displayed.
If the desired bitmap image is not displayed in the list, click [Open] and select the bitmap
image you created.
Select a bitmap image for [ON] and click [Select].
25.4
Image File 3D Part Conversion
25
25-23
Advertisement
Table of Contents
