FE MONITOUCH V8 SERIES Reference: Additional Functions page 498

[Ladder Transfer Setting] in LadderComOp
1. From the [Start] menu of your computer, click [Programs] → [V-SFTV5] → [LadderComOp] →
[Ladder Transfer Setting]. The [Ladder Transfer Setting] dialog is displayed.
2. Check the box for [ COM port].
Select a COM port* which is not used by the software or tools in your computer. Select [USB]
under [Transfer Port].
When [ COM port] is checked, every serial communication that uses the COM port
you selected will be converted to communication via USB or Ethernet.
Therefore, be sure that the COM port selected under [COM port] is not already used for
other serial communications.
Except when ladder transfer via USB/Ethernet is used, uncheck the box for [
port].
* The above [COM port] setting must be the same as the COM port setting in the ladder
software for the PLC. For more information, refer to "COM Port Setting for PLC" (page
27-10).
The range of the usable COM port numbers depends on the PLC programming software.
For more information, refer to the manual for your PLC.
Example: COM port Nos. 1 to 15 available with Panasonic FPWIN GR (COM ports limited to
Nos. 1 to 5 for version 2.2 or earlier)
3. The necessary settings have been completed.
27 Ladder Transfer via USB or Ethernet
[COM port]: COM1 - 256 (COM9 as default)
27
COM
27-7