FE MONITOUCH V8 SERIES Reference: Additional Functions page 449

25.4 Image File 3D Part Conversion
Step 4 Choose the part type.
Choose [Switch] here.
Step 5 Specify the number for [No. of Patterns]. Select "2" here.
In the case of [Switch] or [Lamp] parts, select as many bitmap images as the number set
for [No. of Patterns]. This is not only for bitmap images for [OFF] but also those for [ON]
must be selected. (If not selected, the same bitmap images as those selected for [OFF]
are also used for [ON].)
Step 6 Click the [ON] button.
25-20