12 June 1987
3. Transfer and Separation Corona Wires Replacement
1.
O p e n t h e f r o n t c o v e r a n d r e m o v e t h e T C / S C u n i t c o v e r [ A ] ( 2
screws). Then, disconnect the two cleaner motor connectors [B].
2.
Lower the transport unit and slide out the TC/SC unit [C].
3.
Remove the paper guide [D] lifting it from the rear. Then, remove the
cleaner cover [E] (1 screw).
4.
Remove the rear and front endblock covers [F] (2 screws from the
front). Then, replace the wires.
CAUTION: When installing the transfer corona wire [G], confirm that the ring [H] is
installed on the wire.
3-56