Table of Contents
Advertisement
12 June 1987
9.
Remove the hot roller gear [A] and bearings [B] and collars [C] from
both ends of the hot roller [D] (1 C-ring each).
10.
Slide the hot roller slightly to the rear and remove the hot roller as
shown.
11.
Tear the protective paper [E] from the ends of a new hot roller [F]
and install it.
12.
After the new hot roller is installed, remove the remaining protective
paper.
NOTE:
W h e n r e i n s t a l l i n g t h e f u s i n g l a m p , m a k e s u r e i t d o e s n o t
touch the inside of the hot roller.
3-28
Advertisement
Chapters
Table of Contents
