KEY COUNTER HOLDER INSTALLATION
1. Remove the front cover (2 screws).
2. Remove the right inner cover (4 screws) and right front cover (1 screw).
3. Remove the cover plate [A] and fixing plate [B] from the key counter bracket [C].
4. Hold the fixing plate on the inside of the key counter bracket and insert the key counter
bracket. Insert the key counter holder [D].
5. Align the holes in the fixing plate with the mounting holes of the key counter holder and
secure the key counter holder.
NOTE: The fixing plate has three sets of holes. Make sure to use the holes that match
the type of counter.
6. Remove the shorting plug [E] from the key counter connector [F].
7. Plug in the key counter harness [G].
8. Reassemble the copier. Insert the key counter and check its operation.
NOTE: Counfirm that SP 90 (Secret mode) is set in "No" position.
11-13