Ricoh FT5580 Service Manual page 154

7. Loosen the front wire tightener (1 screw).
8. Remove the right lift rod from the braces (front side first).
9. Disengage the front end of the left lift rod by raising it midway; then,
lift it out from the top.
10. Remove the inner cover (2 short and 2 long screws).
11. Replace the tray down sensor (1 screw and 1 connector).
1 2 . R o t a t e t h e p a p e r s i z e d i a l t o a s m a l l e r s i z e , s u c h a s A 4 R , a n d
remove the positioning switch bracket (1 screw).
13. Replace the positioning switch (2 screws).
NOTE: When reassembling, make sure that the hole-marked ends of
the lift rod are front side.
7-7
12 June 1987