Ricoh FT5580 Service Manual page 167

8. If a customer requests a different paper size from that initially set,
c h a n g e t h e p o s i t i o n o f t h e s i d e p o s t s a c c o r d i n g l y . ( A 4 s i d e w a y s
d o e s n o t n e e d t h e f r o n t s i d e p o s t ) . T h e n , r e m o v e t h e f r o n t c o v e r
[A], and set Dip switch 101 [B] according to the paper size. (Dip
switch table decal is stack on the rear of the front cover.)
CAUTION: Be careful not to change the harness that runs between the LCT main
board and LCT indicator panel.
9. Insert the tray into the second cassette position.
Make sure that the rib [C] fits into the groove [D].
NOTE:
10. Install the holder plates [E] (1 screw each).
8-3
12 June 1987