31 August 1989
8.3 Transfer and Separation Corona Wires Replacement
1. Open the front cover and remove the TC/SC unit cover [A] (2 screws). Then, disconnect
the two cleaner motor connectors [B].
2. Lower the transport unit and slide out the TC/SC unit [C].
3. Remove the paper guide [D], lifting it from the rear. Then, remove the cleaner cover [E] (1
screw).
4. Remove the rear and front endblock covers [F] (2 screws from the front). Then, replace
the wires.
CAUTION: When installing the transfer corona wire [G], confirm that the ring [H] is
installed on the wire.
5-62