Table of Contents
Advertisement
SERVICE PROGRAM MODE OPERATION
The service program mode is used to check electrical data and change
modes or adjustment values.
1. Service Program Access Procedure
1.
Turn the main switch off.
2.
Remove the DIP switch cover on the Operation Panel and turn on DIP
SW 801-8, then turn the main switch on.
NOTE:
At this point the guidance display will prompt...
"PROGRAM No." . . . . . . . . . . . . . . No. 5 —
3.
Using the numeric key board, enter the desired SP mode number
according to the Service Program Mode Table. The SP program can
also be selected with the magnification keys (+, -), in this case SP
numbers are scanned through. After selecting an SP number, press
the ENTER key (#).
To cancel an already entered program, press the clear key.
NOTE:
Also, if an invalid SP number is entered, "Press Clear key" is
displayed.
4.
To abandoned SP mode, turn the main switch OFF, set DIP SW 801-8
to the off position, and turn the main switch on.
2. Change Adjustment Values or Modes
1.
Follow steps 1-3 of the preceding procedure.
2.
Factory setting values or mode will be displayed in the Guidance
Display.
3.
Enter the desired value or mode using the numeral keys according to
the Service Program Mode table.
4.
Turn off the main switch, set DIP SW 801-8 to the off position, and
turn the main switch on.
The
following procedure can also be used to access program numbers 80, 81, 90, 91,
and
92 instead of using DIP SW 801-8.
1.
Press the Mode Clear key.
2.
Press the Clear/Stop key.
Press the Enter key, simultaneously the Guidance Display prompts
3.
"PROGRAM No." . . . . . . . NO. 80
2-7
12 June 1987
Advertisement
Chapters
Table of Contents
