Ricoh FT5580 Service Manual page 129

12 June 1987
(Reverse Side Original)
f) Turn off the copier main switch and set DIP SW 101 [A] on the
DF main PCB as follows:
ON : 101-3, 4
OFF : 101-1, 2
g ) T u r n o n t h e c o p i e r m a i n s w i t c h a n d s e t t h e t e s t c h a r t o n t h e
feed-in table. (facing up with the leading edge to the right.)
h) Press switch 101 [B] on the DF main PCB twice.
Press the Start key to make a copy, then press switch 102 [C]
i)
to feed out the test chart.
A d j u s t t h e D F r e g i s t r a t i o n a g a i n s t t h e p l a t e n r e f e r e n c e m o d e
j)
("PM") by using VR-102 [D] on the DF main PCB.
PM > DF:
PM < DF:
k) Continue to repeat steps "i)" and "j)" until you achieve the same
registration as in step "b)".
Turn VR 102 clockwise
Turn VR 102 counterclockwise
5-6