Table of Contents
Advertisement
12 June 1987
- Common Procedure for Front and Rear Wire -
The running directions for front and rear wire are opposite.
1.
Loosen the wire tightener (1 screw).
2.
Insert the bead (A) (unmarked) into a slot
3.
L o o p t h e w i r e a r o u n d t h e d r i v e p u l l e y ,
turns).
4.
R u n t h e w i r e o v e r W P 1 , W P 2 , W P 3 , a n d W P 4 i n t u r n w h i l e a l s o
placing the lift rod's ends in the braces.
5.
Insert the bead (B) (red) into a slot of the drive pulley.
6.
L o o p t h e w i r e a r o u n d t h e d r i v e p u l l e y , a s s h o w n ( t w o a n d a h a l f
turns).
7.
Hang the wire on the tension pulley.
of the drive pulley.
as shown (one and a half
7-10
Advertisement
Chapters
Table of Contents
