12 June 1987
4. Paper Volume Cord Replacement
1. Unplug the tray and remove the rear cover (4 screws).
2. Remove the transformer assembly with the tray main board (1 screw,
5 connectors, and 1 nylon clamp).
3. Remove the drive motor assembly with the paper volume detection
assembly (2 screws and 2 connectors).
4. Remove the drive motor worm gear (1 Allen screw).
5. Remove the washer and the paper volume cord pulley (1 screw).
6. Rotate the drive shaft so that the slot is vertical, then secure the
shaft with tape.
7. Insert the both ends of the paper volume cord into the slot of the
paper volume cord pulley and run the cord as shown in the figure.
7-12