Tapping Screw M4 X 8 - Ricoh FT5580 Service Manual

12 June 1987
7. Install the original feed table [A] on the right side of the belt unit (4
pan head screws - M4 x 6). (Be sure to engage the 2 hooks [B] of
the original table with the docking holes [C] of the belt unit.)
8. Install the original table cover [D] under the original table (3 pan head
s c r e w s - M4 x 6).
9. Pass the DF interface harness [E] through the hole in the harness
bracket [F], and install the harness bushing [G]. Then, secure the
harness bracket to the copier (1 tapping screw - M4 x 8).
10. Remove the fiber optics adapter [I], (this adapter is not needed for
this installation.) and connect the optic cable [J] to CN112 [K] on the
copier main board.
11.
Connect the free connector (4P White [L]).
12. Secure the ground wire [M] (1 ground screw and toothed washer).
13. Secure the harnesses with a clamp [N] (1 pan head screw - M4 x 6),
and reinstall the rear cover.
5-4