Ricoh FT5580 Service Manual page 215

13 .
Mount the sorter on the copier through the docking holes [A].
14. Pass the sorter's harnesses through the rectangular docking hole [B].
15. Remove the main board shielding plate (2 screws) and swing the board
[C] to the left (2 screws), then connect the red 2P connector [D] to the red
2P free connector and the white 4P connector [E] to the white 4P free con-
nector.
16.
Connect the harness from the sorter to CN 108 [F] on the main board.
Secure the ground wire [G] as shown (toothed washer [H] is also to be in-
stalled for the European version).
17. Secure the sorter to the sorter adapter by fixing the brackets [I] while lifting
them up (1 screw each).
18. Remount the upper, front, and rear covers.
12-5