Ricoh FT5580 Service Manual page 220

1 Feb. '88
4 . S P O N G E R O L L E R R E P L A C E M E N T
1. Turn off the main switch.
2. Remove the sorter from the copier. (See Sorter Removal.)
3 . F r o m t h e s o r t e r r e a r s i d e , r e m o v e t h e m o t o r d r i v e p u l l e y [ A ] ( 1 A l l e n
screw); then, remove the gear [B] of the sponge roller shaft (1 E-ring) and
the parallel pin [C].
N O T E : Be sure not to lose the parallel pin.
4. Remove the lower guide plate [D] with the upper guide plate [E] (2 screws
each from the front and the rear side).
N O T E : * Be sure not to damage the inlet sensor when removing the guide
plate.
* One of the rear side screws is a flat head screw [F].
12-10