Fourth And Fifth Mirror Drive Wire Replacement - Ricoh FT5580 Service Manual

4. Fourth and Fifth Mirror Drive Wire Replacement

1. Remove the exposure glass.
Then, remove the top cover (9 screws), the lens housing cover (4
screws), and the exposure harness guide plate [A] (2 screws).
2. Remove the tension spring [B] and the old wire [C].
3. Route the wire in the following order:
Hook one end of the wire [D] into the anchor point [E] on the
(1)
fourth and fifth mirror assembly (near the tension pulley).
Wrap the wire clockwise around the tension pulley.
(2)
(3) From lower to upper, wrap the wire 2.5 times clockwise around
the drive pulley.
(4) H o o k t h e o t h e r e n d o f t h e w i r e [ F ] o n t o t h e f o u r t h a n d f i f t h
mirror assembly [G].
Hook up the tension spring and reassemble.
(5)
(Refer to "Exposure Glass Removal.")
3-7
12 June 1987