Ricoh FT5580 Service Manual page 70

9. Assemble the
until the shaft
NOTE: When installing the cam holder and the cam rider, align X
Y as shown in the figure.
Make sure that the end of the spring is in the small hole
the rear side plate.
10. Install the pawl shaft pin.
11. Push the spring collar [A] to the rear and rotate
shown in the figure.
NOTE: Make sure that the end of the spring is
in the groove of the collar.
12. Reassemble.
pawl shaft assembly
touches the rear side
Set the collar on the pin [B].
and slide it into the cleaning unit
plate.
3-19
12 June 1987
it with one turn
correctly positioned
and
on
as