Jogger Wire Replacement - Ricoh FT5580 Service Manual

12 June 1987

8. Jogger Wire Replacement

1. Remove the jogger unit.
2. Slide both the front and rear jogger fences [A] to align the screws
[B] and holes [C]. Then, remove the screws.
3. Unhook the spring [D] and remove the old wire [E].
4. Turn over the jogger unit, and place the eyelet [F] (the one furthest
from the ball) on the anchor pin [G]. Then, route the wire as follows:
(1) Wrap the wire counterclockwise around the lower track of WP1
[H] .
(2) Wrap the wire counterclockwise, from lower to upper, around the
jogger motor pulley [I].
5. Connect both ends of the wire with the spring [J].
6. Adjust the jogger home position.
(Refer to "Jogger Unit Removal.")
(Refer to the adjustment table.)
3-42