12 June 1987
5. TC/SC Cleaner Drive Wire Replacement
1. Remove the TC/SC wires.
Wires
Replacement.")
2. Remove the rear endblock [A] (1 screw) while holding it firmly, since
it may spring away.
3. Remove the drive gear [C] and the pulley [D] from the front side.
Then, replace the drive wire [E].
4. Reassemble.
NOTE:
Then, remove the drive pulley [B].
Make sure that the spring that acts upon the home position
sensor actuator is seated correctly.
(Refer to "Transfer and Separation Corona
3-58