Charge Cleaner Drive Wire Replacement - Ricoh FT5580 Service Manual

4. Charge Cleaner Drive Wire Replacement

1 . R e m o v e t h e
Replacement.")
2. Remove the drive wire tension springs [A], drive gear [B], and the old
drive wire [C].
3. Wrap the new wire around the drive pulley one and one-half times
[D].
4. Place the drive ring [E] over the post of the wire cleaner [F].
5. Slip the wire over the idle pulley [G].
6. Install the wire.
7. Reassemble the corona unit.
NOTE: M a k e s u r e t h a t t h e c o r o n a w i r e i s p o s i t i o n e d b e t w e e n t h e
cleaner pads.
SP-7.
Make sure that the spring that acts upon the home position
sensor actuator is seated correctly.
c o r o n a w i r e s .
Also, check the wire cleaner movement using
( R e f e r t o " C h a r g e C o r o n a W i r e
3-57
12 June 1987