Ricoh FT5580 Service Manual page 160

Insert the paper volume cord pulley and washer. Partially tighten the
8.
screw.
NOTE:
Align the slot of the paper volume string pulley with the slot
of the drive shaft.
9. Pull the ends of the cord to stretch it before tightening the screw
and cutting off the excess cord.
10. Remove the tape on the drive shaft and turn the drive pin 3300 in
the direction shown in the figure (A).
11. Set the drive motor worm gear on the motor shaft and make sure the
angle of the drive pin is as shown in the figure (B).
12. Align the edge of the paper volume sensor actuator plate with the
bracket as shown and secure the actuator plate with tape.
7-13
12 June 1987