Fonts; Output Feature - Fuji Xerox ApeosPort 450 I User Manual

Fonts

This section explains the fonts used for emulation.
Available fonts
Available fonts are the followings:
Roman
Sans serif
User-defined Characters
On this machine, you can use user-defined characters. User-defined characters can be
stored only in the memory. Therefore, they are erased when the machine is switched
off. When an internal hard disk is added to the machine, user-defined characters can
be stored on the hard disk, and are not erased even when the machine is switched off.
The volume of user-defined characters that can be stored in the add-in hard disk drive
is the same as the volume when stored in the memory.
The total capacity of memory for storing user-defined characters and other user-
defined data can be set on the control panel. This value is retained after the machine
is switched off.
User-defined characters are registered as bitmap fonts, and cannot be shared among
different printer languages.
Font Cashing
To ensure hi-speed printing, outline fonts of up to a certain size are cashed. Outline
fonts are converted into bit map data temporarily and then printed. To minimize this
processing time, the processed bit map data is saved in the memory. This process is
called font cashing.
The saved bit map data is deleted upon power-off or system reset.

Output Feature

This section describes the machine's output feature.
Outputting a Pending Print Job
The jobs received by the printer can be prioritized over other jobs.
For information on how to give priority to the jobs received by the printer, refer to"Preferentially
Printing Pending Jobs" (P.380).
Using ESC/P Emulation
543
17