Receiving Problems - Fuji Xerox ApeosPort 450 I User Manual

The image quality is poor.

Receiving Problems

Follow the procedure below if you cannot receive a fax.
The phone line has a
problem.
The receiving operation is
incorrect.
Cause
Action
Cause
Action
Cause
Action
Cause
Action
Cause
No Action
Cause
Action
Cause
No Action
Cause
Action
The Login Setup/Auditron Administration feature is used
and the fax is sent directly from the computer.
When the Login Setup/Auditron Administration feature is
used and you send a fax directly from the computer, you
must set the user ID and password registered on the
machine to the fax driver.
For information on the Login Setup/Auditron Administration
feature, refer to "Login Setup/Auditron Administration" (P.359).
For details on how to send a fax directly from the computer,
refer to "CentreWare Internet Services" (P.220) and "Sending
Fax" (P.232).
The document glass is dirty.
Clean the document glass.
Refer to "Cleaning the Film and Constant Velocity Transport
Glass" (P.440).
The fax density is improper.
Adjust the fax density.
Refer to "Lighten/Darken (Adjusting Density Level)" (P.119).
The destination machine has a problem.
Check the condition of the destination machine.
Note • Image quality may be affected by a problem of the
destination machine, as well as a problem of this
machine.
The phone line is not connected correctly.
The machine equips some connectors to connect phone
lines to. The communication is disabled unless the phone
line is connected to a correct connector. When the cable
connection is correct, the on-hook feature allows you to
call through general lines.
An error occurred with the phone line.
Use a telephone near the machine to check whether to be
able to make a phone call. If the phone call is disabled, the
problem is the phone line, not the machine.
The machine is powered off.
The machine does not receive a fax while powered off.
Turn the power switch on.
No paper is set.
Set paper on the machine to receive faxes.
Trouble during Faxing
463
16