Table of Contents
Advertisement
F Code Method
When using the machine as the initiating station for performing remote Relay Broadcast
Send, confirm the F Code and the password (if necessary) for the primary relay station.
When using the machine as the primary relay station for performing remote Relay
Broadcast Send, inform the initiating station of the F Code (sub-address) and the
password (if necessary) and confirm the F Code for the secondary relay station.
When using the machine as the secondary relay station for performing remote Relay
Broadcast Send, inform the primary relay station of the F Code and the password (if
necessary).
Register the following information in the address numbers of the primary relay station
and the secondary relay station in advance.
Where
Primary
relay
station
Secondary
relay
station
Important • When using the F Code method for remote Relay Broadcast Send, the primary relay stations
Note
*When the Speed Dial Extension Kit is installed, it will be 001 to 999.
When using the machine as a relay station, the F Code that is transmitted to the
initiating station is as follows.
Relay Broadcast
Send
Relay Broadcast
Number of digits of primary relay station
1: For primary relay station IDs and address numbers that are 2 digits
2: For primary relay station IDs and address numbers that are 3 digits
Assign the initiating station either to an address number from 001 to 500
the specification method for the initiating station is 3 digits in F Code) or to 001
to 099 (when the specification method for the initiating station is 2 digits in F
Code). Then, set Relay Station Setup of the address number to [On].
Assign the secondary relay station either to an address number from 001 to
*
500
(when the specification method for the initiating station is 3 digits in F
Code) or ton001 to 099 (when the specification method for the initiating station
is 2 digits in F Code).
As the relay station ID, assign the last two digits of the Address Number for
the primary relay station that is registered to the secondary relay station.
As the broadcast recipients, assign the Address Number for the relay
recipients that have been registered to the secondary relay station.
Assign the primary relay station to the same address number as that of the
initiating station registered at the primary relay station, and set Relay Station
Setup of the address number to On.
Assign the relay recipients either to an address number from 001 to 500
the specification method for the initiating station is 3 digits in F Code) or to 001
to 099 (when the specification method for the initiating station is 2 digits in F
Code).
and secondary relay stations must support our F Code method and be equipped with the
Relay Broadcast feature.
• When performing Relay Broadcast Send with machines of this model, we recommend using
the fax signal method.
Print
First relay
directive
station ID
Up to 20 digits
Contents
Address
Address
Address
Number
Number
Number
Broadcast
*
(when
4
*
(when
....
151
Advertisement
Table of Contents
