Table of Contents
Advertisement
17 Appendix
On-hook Dialing
1
2
3
17
4
5
584
The following describes how to place a call with the receiver on-hook. When placing a
call on-hook, we recommend turning the line monitor volume to "Loud".
The volume of the line monitor can be changed in the System Administration mode. For information on
how to change the volume, refer to "Line Monitor Volume" (P.269). By factory default, the volume is
set to [Normal].
On the [All Services] screen, select
[Fax/Internet Fax].
Select [On-hook (Manual Send/
Receive)] on the [On-hook/Others]
screen.
Specify the call destination.
The call destination can be specified using the numeric keypad, address numbers,
or one touch buttons. The address book cannot be used.
The call destination can be
specified also with the keyboard
displayed by pressing
[Alphanumeric] or [Symbol]
buttonTo cut the line, select [Exit
(Line Cut)]..
• If your telephone line is set to
touch-tone, [Tone (:)] does not
appear.
• If you want to send tones (or
to use the touch-tone
services) while using a pulse
line, select [Tone (:)].
• Some touch-tone services
may not be available even if
you set your telephone to
send tones.
When the call is connected, lift the
receiver and start speaking.
After the call is finished, place the
receiver back in the cradle.
Important • Make sure that the receiver is placed properly in the cradle. Otherwise, the line will remain
"busy".
Advertisement
Table of Contents
