Table of Contents
Advertisement
5 Scan
Scan Size (Specifying a Scanning Size)
You can set the scanning size for the document.
Specify the scan size to scan non-standard size documents or to scan with the different
size from the original document size.
When the size is specified, the document is scanned at the specified size regardless of
the original document size. This feature allows you to add or delete the document
margins.
1
Select [Scan Size].
2
Select a size.
Auto Size Detect
Detects the document size automatically.
Refer to the table in "Paper Size Settings" (P.282) for the document sizes automatically detected.
Note
Standard Size
Select a document size from 11 sizes.
5
Free
Enter the desired scan size to scan non-standard size documents or to scan with the
different size from the original document size. Set the size in the document glass X
(horizontal) direction within the range of 15 to 432 mm and in the Y (vertical) direction
within the range of 15 to 297 mm, in 1 mm increments. The scale on the outside of the
document glass is a useful reference for specifying the document size.
Mixed Size Originals (Scanning Different Size Documents Simultaneously)
When using the document feeder, you can simultaneously scan different size
documents with the respective sizes. You can also specify a size to scan different size
documents with the same size.
Note
184
• If the document size cannot be detected automatically, a screen appears to allow you to
enter the document size.
• The standard document sizes automatically detected depend on [Paper Size Settings] in the
System Administration mode. For information on the paper size settings, refer to "Paper Size
Settings" (P.282).
• Always load the A5-size documents vertically.
• When loading a B5 size document with A3 or A4 size documents in a vertical direction, place
the B5 document also in a vertical direction.
• The recommended document size combinations are A4 portrait and A3 landscape, or B5
portrait and B4 landscape. If the combination of the document sizes is not our
recommendation, the documents can be fed at an angle may not be copied properly.
• This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• When [Reduce/Enlarge] is set to [Auto %] and the output size is specified for [Output Size],
the scanned data is automatically reduced/enlarged to the specified size.
• If the document size cannot be detected automatically, a screen appears to allow you to
enter the document size.
Advertisement
Table of Contents
