Fuji Xerox ApeosPort 450 I User Manual page 552

17 Appendix
Setting Item
Form overlay
Stapling
Hole punching
Number of holes
Binary character
17
strings
550
Item
Number
64 Constantly performs Form Overlay by selecting a form name (No. 01-64)
registered on the machine.
[0] (Default)
[1-64]
Important • Since this setting selects the default value, it is not affected when an
extended commend is received.
• Once a form name is selected, it will remain displayed even if the
form is deleted. When a form name is selected using the up and
down arrow keys, it will not be displayed. In this case, the setting is
set to "Off".
66 Sets the stapling position.
[0] (Default)
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
69 Sets the hole-punching position.
[0] (Default)
[1]
[2]
[3]
[4]
70 Select the number of punch holes.
[0] (Default)
[1]
[2]
72 Sets the specified character strings when entering commands in
hexadecimal format.
[0] (Default)
[1]
[2]
Value
: Off
: No. 1 - No. 64
: Off
: Top left
: Top Double
: Top Right
: Left Double
: Right Double
: Bottom Left
: Bottom Double
: Bottom Right
: Off
: Top
: Bottom
: Left
: Right
: 2 holes
: 3 holes
: 4 holes
: Off
: &$%$
: &?!#