Table of Contents
Advertisement
Active Area
Determining
Command
Paper Margin
Image
Enhancement
Stapling
Manual Feed Tray
Check Indicator
Punching
Number of holes
161
0 (Default): Auto
1: PS
2: IW
3: IP
4: Adapted
When auto-scaling is in use, this sets the method for
obtaining the active coordinate area.
[Auto]...Determines any of the methods listed below: PS,
IW, IP, or Adapted.
[PS]...Area specified by the first PS command is to be a
rectangular area.
[IW]...Area specified by the very last IW command is to
be a rectangular area.
[IP]...Area which combines all the IP Commands is to be
a rectangular area.
[Adapted]...The maximum/minimum coordinates within
the areas and coordinates plotted using the drawing
command, and the maximum size of characters and line
width specified in the page, are used to calculate the
rectangular area.
162
0 to 99 (Default): 0): 0 - 99 mm
Sets the paper margin when auto scaling is being used.
163
0: OFF
1 (Default): ON
Sets whether to artificially increase the resolution of an
image and smooth its edges.
164
0 (Default): None
1: Top Left
2: Top Double
3: Top Right
4: Left Double
5: Right Double
6: Bottom Left
7: Bottom Double
8: Bottom Right
9: Center
Sets the stapling position.
165
0: None
1 (Default): Yes
166
0: None
1 (Default): Top
2: Bottom
3: Left
4: Right
Sets the punch position.
167
0 (Default): 2 holes
1: 3 holes
2: 4 holes
HP-GL2 Emulation
17
565
Advertisement
Table of Contents
