Table of Contents
Advertisement
Category
Error Code
C P F S M O
078-210
078-212
078-250
112-700
116-701
O O
116-702
O
116-703
O
116-710
O
116-713
116-714
O
116-720
O
116-740
O
116-747
O
116-748
O
116-749
O
O [Cause]
Tray 6 (high capacity) malfunction
[Remedy] Contact our Customer Support Center.
O [Cause]
The finisher's punch scrap container is full.
[Remedy] Empty the punch scrap container.
For details on how to empty the punch scrap container, refer to "Emptying
the Punch Scrap Container (When a C Finisher/C Booklet Finisher is
Installed)" (P.436).
[Cause]
Unable to use the 2-sided printing feature due to
insufficient memory.
[Remedy] Add on memory, or attach a HDD if it is unattached.
[Cause]
Printing was performed using a substitute font.
[Remedy] Check the print data.
[Cause]
An error occurred during PostScript (optional) processing.
[Remedy] Either check the print data, or click [Spool Settings] on the
[Details] tab in the print driver to set bi-directional
communication off.
[Cause]
A probable cause is that the correct document size could
not be judged as the receive data exceeded the HP-GL/2
spool size.
[Remedy] Increase the size assigned to HP-GL/2 auto-layout
memory.
O [Cause]
Job was divided and printed due to insufficient disk
space.
[Remedy] Remove unnecessary data from the hard disk to increase
free disk space.
[Cause]
An HP-GL/2 command error occurred.
[Remedy] Check the print data.
[Cause]
An error occurred during print processing due to
insufficient memory.
[Remedy] Stop unnecessary ports or remove unnecessary data
from the hard disk, to increase free disk space.
[Cause]
A numerical value operation error occurred because a
value used in the print data exceeded the limit of this
machine.
[Remedy] Check the print data.
[Cause]
The paper margin value is too large for the HP-GL/2
effective coordinate area.
[Remedy] Decrease the paper margin value, and try again.
[Cause]
There is no plot data in the HP-GL/2 print data.
[Remedy] Check the print data.
[Cause]
The job was canceled because the specified font does not
exist.
[Remedy] Install the font, or set the font replacement on the print
driver.
Cause and Remedy
Error Code
16
497
Advertisement
Table of Contents
