Table of Contents
Advertisement
4 Fax
Relay
station
Note
*When the Speed Dial Extension Kit is installed, it will be 001 to 999.
Fax Signal Method
4
1
Select an address number or group dial number to which a relay broadcast is
registered and press the <Start> button. To perform Multiple Relay Broadcast, repeat
this step.
DTMF Method
There are two methods in the DTMF method: Auto Send and Manual Send.
Auto Send (transmitting without picking up the telephone)
1
Select [Keyboard] to display the keyboard on the touch screen and enter the following
format.
2
Select [Next Recipient] to perform Multiple Relay Broadcast.
Note
Note
146
Where
Fax Signal Method
Assign the initiating station to an address number from 001 to 099 and set
Relay Station Setup of the address number to [On].
Assign the relay recipient to an address number from 001 to 099. The relay
recipients can also be assigned group dial numbers from the initiating station.
DTMF Method (G3)/F Code Method
Assign the initiating station either to an address number from 001 to 500
(when the specification method for the initiating station is 3 digits in F Code)
or to 001 to 099 (when the specification method for the initiating station is 2
digits in F Code). Then, set Relay Station Setup of the address number to
[On].
Assign the relay recipients to an address number.
Assign the relay recipient either to a relay station address number from 001 to
*
500
(when the specification method for the initiating station is 3 digits in F
Code) or to 001 to 099 (when the specification method for the initiating station
is 2 digits in F Code).
• The above describes using Relay Broadcast with the machine. When using a machine of a
different model as a relay station, check the F Code (sub-address) and password of the
target recipient machine.
• You can specify up to 20 locations for relay recipients.
Password
A pre-registered two-digit number
• By default, no password is set. For setting a password, contact our Customer Support
Center. If a password has not been set, you do not need to enter one.
Relay station ID
The last two digits of the initiating station address number registered at the relay
station.
Address number
An address number for the relay recipients registered at the relay station.
The wildcard "
" can also be used.
∗
Contents
Address
Address
number
number
*
Advertisement
Table of Contents
