Table of Contents
Advertisement
Category
Error Code
C P F S M O
016-718
O
016-719
O
016-720
O
016-721
O
016-722
O
016-723
O
016-724
O
016-726
O
016-728
O
016-729
O
016-731
O
016-732
O
[Cause]
Unable to process the PCL print data due to insufficient
memory.
[Remedy] Reduce the resolution, or cancel 2-sided printing or N up,
and then print again.
[Cause]
Unable to process the PCL print data due to insufficient
print page buffer.
[Remedy] Increase the size of the print page buffer.
[Cause]
An invalid command is included in PCL print data.
[Remedy] Check the print data and try to print again.
O [Cause]
An error occurred during print processing. Probable
causes are as follows:
1. Printing was instructed by [automatic tray selection]
when [Paper Type Priority] is set to [Automatic Tray
switching Off] for all paper in the [Common Settings].
2. ESC/P command error
[Remedy] 1. When printing by automatic tray selection, set one of
the paper types to a setting other than [Automatic Tray
switching Off] in [Paper Type Priority].
2. Check print data.
Refer to "Paper Type Priority" (P.273).
[Cause]
The staple position you specified is unsupported.
[Remedy] Check the staple position and try to print again.
[Cause]
The punch position you specified is unsupported.
[Remedy] Check the punch position and try to print again.
[Cause]
The specified staple and punch position combination is
unsupported.
[Remedy] Specify the staple and punch positions to be on the same
side, and try to print again.
[Cause]
Unable to automatically select a printer language even
though the print mode is set to [Auto].
Probable causes are as follows:
1. PostScript data was sent when the Post Script 3 Kit
(optional) was not attached.
2. The PDF file was sent directly to the machine using
LPR, when the PostScript 3 Kit is attached and a HDD
is unattached to the machine.
[Remedy] 1. The PostScript3 Kit must be installed.
2. A HDD must be installed.
[Cause]
An invalid tag is included in the TIFF file.
[Remedy] Check the print data.
[Cause]
Unable to print because the number of colors or the
resolution of the TIFF file is out of allowed range.
[Remedy] Change the number of colors/resolution of the TIFF file,
and specify the print data again.
[Cause]
Unable to print TIFF data because it was interrupted.
[Remedy] Retry printing.
[Cause]
The form specified by the emulation has not been
registered at the host side.
[Remedy] Resend the form data.
Cause and Remedy
Error Code
16
475
Advertisement
Table of Contents
