Table of Contents
Advertisement
17 Appendix
17
564
Print Quantity Setup
HP-GL Mode
Hard Clip
Eject Command
152 (SP)
153 (SPO)
154 (NR)
155 (FR)
156 (PG)
157 (AF)
158 (AH)
Scaling
Scaling Mode
115
0 (Default): Protocol
1: Panel
2: Command
Sets the method for specifying the print quantity.
150
0 (Default): HP-GL
1: HP-GL/2
A graphics language can be selected.
151
0: Standard
2 (Default): Paper
Sets the size for the area where drawings can be made
(hard clip area).
[Standard]...Hard clip area for A4, A3, letter, and ledger
are the same as for the Hewlett Packard HP7550A. Hard
clip area for other paper sizes is the same as this M/C
printable area.
[Paper]...Make the hard clip area the same area as the
paper.
0 (Default): OFF
1: ON
Sets the command that indicates a drawing is finished.
When the command specified here is received, drawing
is terminated and the paper is ejected.
[Off]...Does not process as an eject command.
[On]...Processes as an eject command.
ON is set as the default for SPO only.
159
0: OFF
1 (Default): ON
Determines the setting to either enlarge or reduce the
document size so that the document size fits the paper
size.
[OFF]...Prints in the same size without enlargement/
reduction, even if the document size and paper size are
different.
[ON]...Prints while enlarging/reducing the data on
document size so that it fits the paper size.
160
0 (Default): Paper Size
1: Active Coordinate Area
Determines how the document size and the paper size
are determined when Document Size (the item number
101) and/or Paper Size (102) is set to Auto (99).
[Paper Size]...Make the document size the minimum size
that combines the active coordinate area from the active
coordinate determining method and the active coordinate
obtained by the settings of Origin Position and Paper
Margin.
[Active Coordinate Area]...Make the document size the
area from which the paper margin is subtracted from the
active coordinate area obtained by the active coordinate
determining method.
Advertisement
Table of Contents
