Table of Contents
Advertisement
Doc for Polling - Auto Delete
Set whether polling documents should be automatically deleted after sending.
Rotate 90 Degrees
If the original can be rotated and sent without reducing the original image, set whether
to automatically rotate the document.
Note
Mixed Size Originals Scanning Mode
If only documents of the standard sizes are scanned, it is recommended to set
[Standard Size Mode].
Important • If documents listed below are scanned when [Standard Size Mode] is selected, image loss
Skip Blank Pages
Set whether to use the feature that detects blank sheets while scanning 2-sided
documents and transmits only documents whose surface is not blank.
Note
Sender ID
For G3 communications, you can select whether to notify the G3-ID to recipients.
Redial Attempt
The redial feature automatically redials when the recipient is busy, or does not respond
for any other reason. Set the number of redials from 0 to 9.
Redial Interval
Set the redialing interval from 0 to 15 minutes in 1 minute increments.
Transmission Interval
Set a value for the interval between the end of one transmission and the beginning of
the next, from 3 to 255 seconds in 1 second increments.
A longer transmission interval increases the total time to send a broadcast
transmission, for example, but allows calls to be received during the standby time.
Batch Send
A batch send means that when multiple transmissions have been stored for the same
address, the documents are sent in a single transmission to the address, and this sets
whether or not to do this. When Batch Send is set, the communications cost can be
reduced. Select whether to use the batch send feature.
Note that a batch send is not possible for manual transmissions, broadcast, relay
broadcast, mailbox transmissions, and transmissions with a specified time before the
specified time. When using a redial, resend, or delayed start send transmission job, to
send to the same address from different users, then a batch send is not possible.
• If an arbitrary magnification is specified in [Reduce/Enlarge], automatic rotation transmission
does not feature.
may occur.
- Non-standard size documents
- B4 size documents when setting the inch series in [Paper Size Settings]
• This feature is for customer engineer use. For more information, contact our Customer
Support Center.
Fax Mode Settings
11
315
Advertisement
Table of Contents
