Brake Pads Replacement (Rear) - GMC chervolet camaro 1999 Service Manual

Brakes
Notice: Refer to Fastener Notice in Cautions and
Notices.
') 3. Install the caliper mounting pin bolts.
\
Tighten
Tighten the mounting pin bolts to 31 N-m (23 lb ft).
4. With the engine running, pump the brake pedal
slowly and firmly until the inner and outer brake
pads are positioned against rotor (firm pedal).
5. Install the tire and wheel assembly. Refer to Tire
and Wheel Removal and Installation (Wheel
Installation) in Tires and Wheels.
6. Lower the vehicle.
7. Refill the master cylinder to the proper level with
clean, fresh brake fluid.
8. Inspect the hydraulic brake system for brake
fluid leaks.
9. Burnish the new pads. Refer to Burnishing Pads
and Rotors.
Brake Pads Replacement (Rear)
Removal Procedure
1. Remove two-thirds of the brake fluid from the
master cylinder.
2. Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle in General
Information.
1
3. Remove the tire and wheel. Refer to Tire and
Wheel Removal and Installation (Wheel Removal)
in Tires and Wheels.
4. Install two wheel nuts in order to retain the rotor.
Disc Brakes 5-61
63984
451525