GMC chervolet camaro 1999 Service Manual page 32

General Information
J
41340
11. Stake the bezel end of the retainer in place:
11.1. Hold the flat side of the punch, part of
65503
J 41340, squarely against the face of the
cylinder bezel.
11.2. Stake the lock cylinder metal over the
retainer comers.
12. Stake the other end of the retainer:
12.1. Remove the punch, part of J 41340.
12.2. Rotate the punch, part of J 41340,
180 degrees.
65504
12.3. Hold the punch, part of J 41340, squarely
against the end of the punch slot on
J41340.
12.4. Stake the metal over the other end of the
retainer.
General Information 0-29
13. Loosen the holding screw.
14. Remove the cylinder from the J 41340.
15. Inspect that the retainer is properly staked.
Restake as needed.
16.
Lubricate the cylinder retainer slot.
17. Insert the following parts into the cylinder
retainer slot:
• The retainer spring (2)
• The retainer (3)
65505
Important:
Use a paste type grease, not a spray, for
the following step.
18. Lubricate the following parts with
GM P/N
12345996
or equivalent as needed:
• The detent pins (1)
• The cylinder retainer (3)
Side Door Lock Cylinder Coding
The side door lock cylinder has five snap-in tumblers.
The number
1-5
positions (beginning closest to
the cylinder head) are a brass retainer tumbler. The
6-10 positions are standard tumbler positions.
Therefore, only the 6-1 O positions are required.