Park Brake Cable Replacement (Rear) - GMC chervolet camaro 1999 Service Manual

Brakes
7. Connect the rear fitting of the front cable conduit
to the floor panbracket (1 ).
') Pull the equalizer (3) back until the
equalizer stops.
Connect the rear cables (2) to the equalizer (3).
8. Lower the vehicle.
9. Cycle the park brake lever (1) three times.
10. Install the front floor console. Refer to Console
Replacement - Front Floor in Instrument Panel,
Gages and Console.
Park Brake Cable Replacement (Rear)
Removal Procedure
Tools Required
J
37043 Parking Brake Cable Release Tool
1. Fully disengage the park brake lever. Ensure that
the handle is down and that the brake indicator
lamp is not lit.
Important:
If the park brake lever is partially engaged,
you will not be able to pull the equalizer rearward
later in this procedure.
2. Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle in General
Information.
3. Pull down on the front cable strand until the
strand stops and stays extended.
4. Cut off the tie strap.
5. Remove the rear cable from the underbody
bracket. ·
Use the J 37043 in order to compress the retainer
fingers on the casing and pull the rear cable
from the underbody bracket.
6. Remove the rear park brake cables (2) from the
park brake cable equalizer (3).
Park Brake 5-91
214860
182210
214860