GMC chervolet camaro 1999 Service Manual page 427

4-12 Propeller Shaft
180343
180344
180337
Driveline/ Axle
9. Inspect the outer diameter of the slip yoke (1)
for burrs.
10. Inspect the outer splines of the slip yoke (1) for (
the following conditions:
• Damage
• Twisting
• Wear
11. Inspect the relationship of the outer splines of the
slip yoke to the transmission output shaft splines.
The outer splines of the slip yoke should meet
the following requirements:
• The outer splines should agree in number with
the transmission output shaft splines.
• The outer splines should fit with the
transmission output shaft splines.
12. Inspect the pinion gear yoke (1) at the universal
joint cap connecting surface for the following
conditions:
• Burrs
• Foreign material
Installation Procedure
Notice: The propeller shaft must be supported
carefully during handling to avoid jamming or bending
of parts.
Important: Do not place any tool between the
propeller shaft slip yoke and the splines. Placing any
tool between the propeller shaft slip yoke and the
splines may cause damage to the
transmission oil seal.
1. Lubricate the slip yoke with chassis lubricant.
2. Install the slip yoke onto the transmission
output shaft.
Important: Be sure to align the mark on the pinion
gear yoke with the mark on the propeller shaft.
(
3. Install the rear of the propeller shaft (2) to the (
pinion gear yoke (1).