GMC chervolet camaro 1999 Service Manual page 724

Brakes
3. If equipped with ABS!TCS, install two wave
springs (1) between the EBTCM and BPMV. Use
locations and orientation noted during removal.
4. Install the EBCM/EBTCM (1) to the BPMV (5).
Notice: Refer to Fastener Notice in Cautions and
Notices.
Tighten
Tighten the top four mounting screws (2) to
2.9 N-m (26 lb in.). Tighten screws in an X pattern.
Tighten
I
Tighten the bottom two mounting screws (2) to
2.9 N-m (26 lb. in.).
5. Connect the pump motor connector (3) to the
bottom of the EBTCM.
6. Connect the EBCM/EBTCM harness connector.
Push in lock tab (1 ).
7. Tum the ignition switch to the RUN position,
engine off.
8. Perform the ABS Diagnostic System Check
Antilock Brake System 5-249
1
255236
2
3
4
213438
1
230405