5-196 Antilock Brake System
Brakes
DTC C0181 Throttle Reduction Motor CKT Malfunction
Step
Action
Value(s)
Yes
No
Go to ABS
I
\
1
Was the Diagnostic System Check performed?
-
Go to Step2
Diagnostic
System Check
1. Turn the ignition switch to the OFF position.
2. Disconnect the Accelerator Control and Adjuster
connector.
3. Disconnect all cables from the Accelerator Control
and Adjuster.
4. Rotate Adjuster by hand fully, then release and allow
2
to return to the stop. Repeat this procedure
three times.
0.5-10!2
Go to Step 4
Go to Step 3
5. Zero the leads on the
J
39200 DMM.
6. Using
J
39200 DMM, measure the resistance
between the Accelerator Control and Adjuster
connector terminals A and B.
Is the resistance within the range specified in the value(s)
column?
Replace the Accelerator Control and Adjuster. Refer to
Go to ABS
3
Adjuster Assembly Replacement.
-
Diagnostic
-
Is the repair complete?
System Check
1. Disconnect the ASM harness connector.
4
2. Using
J
39200 DMM measure the resistance between
OL (infinite)
Go to Step 6
Go to Step 5
the ASM harness connector terminals 22 and 28.
Is the resistance within the range specified in the value(s)
column?
Repair CKT 560 for a short to ground. Refer to Repair
Go to ABS
5
Procedures Cell 5 in Electrical Diagnosis.
-
Diagnostic
-
Is the repair complete?
System Check
Using J 39200 DMM measure the resistance between the
6
ASM harness connector terminals 26 and 28.
OL (infinite)
Go to Step 8
Go to Stepl
Is the resistance within the range specified in the value(s)
column?
Repair CKT 561 for a short to ground. Refer to Repair
Goto ABS
7
Procedures Cell 5 in Electrical Diagnosis.
-
Diagnostic
-
Is the repair complete?
System Check
Using the
J
39200 DMM, measure the resistance between
the ASM harness connector terminal 22 and the
8
Accelerator Adjuster harness connector terminal A.
0-5Q
Go to Step 10
Go to Step 9
Is the resistance within the range specified in the value(s)
column?
Repair CKT 560 for an open. Refer to Repair Procedures
Goto ABS
9
Cell 5 in Electrical Diagnosis.
-
Diagnostic
-
Is the repair complete?
System Check
(