GMC chervolet camaro 1999 Service Manual page 202

HVAC
Installation Procedure
1. Install the temperature control cable spring (4) to
the temperature control cable pulley (2).
2.
Connect the temperature control cable
(5)
to the
heater module.
3. Connect the temperature control cable to the A/C
module.
Notice: Refer to Fastener Notice in Cautions and
Notices.
4. Install the temperature control cable bolt.
Tighten
Tighten the temperature control cable bolt to
1.9 N-m (17 lb in).
5. Install the right 1/P insulator. Refer to Insulator
Replacement - IP (Right Side) in Instrument
Panel, Gauges and Console.
Air Inlet Actuator Replacement
Removal Procedure
1.
Remove the right side insulator. Refer to Insulator
Replacement - IP (Right Side) in Instrument
Panel, Gauges and Console.
2. Remove the left side insulator. Refer to Insulator
Replacement - IP (Left Side) in Instrument Panel,
Gauges and Console.
3. Remove the 1/P compartment door hinge screws.
4. Remove the 1/P compartment door.
5. Remove the HVAC module screws.
6. Remove the HV AC module cover.
7. Disconnect the air inlet valve linkage.
8. Remove the air inlet valve actuator and
vacuum hose.
HVAC System - Manual 1-111
10°- 15°
4
3
282915
282922