Cable Adjustment Procedure; Wheel Speed Sensor Replacement; (Rear With Out Traction Control) - GMC chervolet camaro 1999 Service Manual

i
J
Brakes
Cable Adjustment Procedure
The throttle body, accelerator pedal, and cruise control
cables must be fully installed before making
adjustments.
1. Remove the throttle body lever cover.
2. Unlock the throttle body cable and cruise control
cable adjuster (1).
3. Hold throttle body lever firmly at stop/idle position.
4. Pull the throttle body cable assembly just
rearward of the adjuster lock to remove
slack from cable.
Important: Do not disturb cable after removing slack.
5. Lock the throttle body cable adjuster (1 ).
6. Hold throttle body lever firmly at stop/idle position.
7. Pull the cruise control cable assembly just
rearward of the adjuster lock to remove
slack from cable.
Important: Do not disturb cable after removing slack.
8. Lock the throttle body cable adjuster (1 ).
Important: Cables should never be adjusted so tight
that tension from the cable will not allow the throttle
to close completely. If the cable is adjusted to tight, the
cable will prevent the engine from returning to idle
and will cause unstable idle quality.
Using a scan tool check the throttle angle. When the
accelerator is fully depressed the throttle angle
should read 100 percent. When the accelerator is
released the throttle angle should read O percent. .If
proper results are not obtained check cables for kinks
or damage and repeat procedure.
Wheel Speed Sensor Replacement
(Rear With Out Traction Control)
Removal Procedure
1. Remove the wheel speed sensor connector.
2. Clean all dirt and debris from sensor
housing/sensor interface area.
3. Remove the Wheel Speed Sensor bolt (3).
4. Remove the Wheel Speed Sf3nsor (4).
Antilock Brake System 5·255
1
2
213432
2
213402