Pivot And Pulse Switch Assembly - Assemble - Off Vehicle; Steering Column Lock Cylinder Set - Disassemble - GMC chervolet camaro 1999 Service Manual

2-90 Steering Wheel and Column - Tilt
343861
354104
Steering
Pivot and Pulse Switch Assembly -
Assemble - Off Vehicle
Assembly Procedure
1. Install the pivot and pulse switch assembly to the
lock housing cover and sleeve assembly.
2. Lubricate the switch actuator pivot pin (2) with
lithium grease.
3. Install the switch actuator pivot pin (2) into the
pivot and pulse switch assembly (1 ).
4. Install the switch actuator pivot pin (2) into the
lock housing cover and sleeve assembly.
5. Pull the pivot and pulse switch assembly wire
harness through the steering column.
Important: Use care not to damage the wires when
pulling the pivot and pulse switch assembly wire
harness through the steering column.
6. Install the pivot and pulse switch assembly
connector to the bulkhead connector.
7. Install the wire protector shield ..
8. Install the lock housing cover and sleeve
assembly. Refer to Lock Housing
Assembly - Assemble.
Steering Column Lock Cylinder Set -
Disassemble
Dlsassembly Procedure
1. Remove the turn signal switch assembly. Refer to
Turn Signal and Multi/en Switch Assembly -
Disassemble - Off Vehicle.. ·
2. Put the key in the "LOCK'' position.
3. Remove the lock retaining screw (2) from the lock
housing cover and sleeve assembly.
4. Remove the steering column lock cylinder set (1)
from the lock housing cover and sleeve assembly.
(
(