Oil Seal And/Or Bearing Replacement - GMC chervolet camaro 1999 Service Manual

.Driveline/ Axle
Oil Seal and/or Bearing Replacement
Removal Procedure
Tools Required
• J 2619 - 01 Slide Hammer
• J 22813 - 01 Axle Bearing Remover
1. Remove the rear axle shaft. Refer to Axle Shaft
Replacement.
2. Place a pry bar behind the steel case of the
seal (3). Use the pry bar in order to remove
the rear wheel bearing seal (3) from the rear axle
housing (2).
Do NOT damage the housing (2).
3. Insert J 22813- 01 into the bore.
Position J 22813- 01 behind the rear wheel
bearing so that the tangs on the tool engage the
bearing outer race.
4. Use J 2619 - 01 in order to remove the rear wheel
bearing.
Installation Procedure
Tools Required
• J 8092 Driver Handle
• J 23765 Axle Bearing Installer
• J 23771 Axle Oil Seal Installer
1. Lubricate the new rear wheel bearing (1 ).
Use one of the following lubricants:
• Axle lubricant
• SAE 80W-90 GL-5 gear lubricant or an
equivalent
Rear Drive Axle 4-35
164285
J 22813-01
J 2619-01
228698
164285