GMC chervolet camaro 1999 Service Manual page 612

Brakes
Antilock Brake System 5-137
DTC C0036 LF Wheel Speed Circuit Range/Performance (cont'd)
\
Step
Action Value(s) Yes No
Repair short between CKT(s) 830 and 873. Refer to Repair
Procedures Cell 5 in Electrical Diagnosis. If a short between
10
wheel speed sensor circuits is found in the jumper harness,
-
replace the jumper harness. Refer to Wheel Speed Sensor
-
Jumper Harness Replacement (Front Left).
Is the repair complete?
Go to Step 16
Using J 39200 DMM, measure the resistance between
11
terminals 20 and 15 of J 39700.
OL (infinite)
Is the resistance within the range specified in the values
column?
Go to Step 13
Go to Step 12
Repair CKT 830 for a short to ground. Refer to Repair
Procedures Cell 5 in Electrical Diagnosis. If a short to
12
ground is found in the jumper harness, replace the jumper
-
-
harness. Refer to Wheel Speed Sensor Jumper Harness
Replacement (Front Left).
Is the repair complete? Go to Step 16
Using J 39200 DMM, measure the resistance between
13
terminals 21 and 15 of J 39700.
OL (infinite)
Is the resistance within the range specified in the values
column? Go to Step 15
Go to Step 14
Repair CKT 873 for a short to ground. Refer to Repair
Procedures Cell 5 in Electrical Diagnosis. If a short to
14
ground is found in the jumper harness, replace the jumper
-
-
harness. Refer to Wheel Speed Sensor Jumper Harness
Replacement (Front Left).
Is the repair complete? Go to Step 16
Replace the EBCM/EBTCM. Refer to Electronic Brake
Goto ABS
15
Control Module (EBCM) Replacement.
-
Diagnostic
-
Is the replacement complete? System Check
1. Reconnect all previously disconnected components.
2. Using a scan tool clear the DTC.
16
3. Remove the scan tool from the DLC.
-
4.
Carefully drive vehicle above 12 Km/h (8 mph) for
Goto ABS
several minutes.
Diagnostic
Does the OTC reset as a current OTC? GotoStep2 System Check