GMC chervolet camaro 1999 Service Manual page 453

4-38 Rear Drive Axle
164048
J8614-2
164041
Driveline/Axle
9. If the drive pinion gear yoke is damaged, replace
the drive pinion gear yoke.
10. Inspect the housing bore for burrs. (
Burrs might cause leaks around the
outer diameter (OD) of the drive pinion gear
seal (1).
Remove any burrs that might cause leaks around
the outer diameter (OD) of the drive pinion
gear seal (1).
Installation Procedure
Tools Required
• J 8614 - 01 Pinion Flange Remover and Installer
• J 23911 Pinion Oil Seal Installer
1. Use the J 23911 in order to install a new drive
pinion gear seal (1 ).
2. Apply chassis lubricant or an equivalent to the
following components:
• The outside diameter of the drive pinion
gear yoke
• The sealing lip of the new drive pinion gear
seal (1)
3. Install the drive pinion gear yoke (1 ).
4. Install the following components:
• The drive pinion gear washer
• The drive pinion gear nut
Finger tighten the drive pinion gear nut.
(
(