Master Cylinder Replacement - GMC chervolet camaro 1999 Service Manual

)
Brakes
Master Cylinder Replacement
Removal Procedure
1. Remove and discard the brake fluid from the
reservoir.
2.
Remove the brake combination valve pipes in
order to prevent fluid loss and contamination.
3. Disconnect the brake fluid level sensor connector.
4.
Remove the master cylinder nuts.
5.
Remove the master cylinder.
Installation Procedure
1. Bench bleed the master cylinder. Refer to Master
Cylinder Bench Bleeding
2. Install the master cylinder.
Notice: Refer to Fastener Notice in Cautions and
Notices.
3. Install the master cylinder nuts.
Tighten
Tighten the brake master cylinder nuts to
29 N,m (21 lb ft).
4. Fill the master cylinder reservoir. Refer to Master
Cylinder Reservoir Filling.
5. Install the brake combination valve pipes onto the
master cylinder one at a time. Complete the
following steps:
5.1. Remove the locally fabricated plugs.
5.2. Install the brake pipe fitting finger tight.
Hydraulic Brakes 5-25
451525
222987
222987